| パートいいえ | メーカー | アプリケーション |
|---|
| MAX6307UK39D2-T | MAXIMIC | Multiple-input, programmable reset IC (open-drain reset output,factory-set reset threshold on Vcc,1additional undervoltage reset input,negative/overvoltage reset inp.).Factory-trimmed reset thresholds3.803(min),3.998(max).Nominal timeout period 20ms. |
| MAX491C/D | MAXIMIC | Low-power, slew-rate-limited RS-485/RS-422 transceiver. Full-duplex. Data rate 2.5Mbps. Slew-rate limited - no. Low-power shutdown - no. Receiver/driver enable - yes. Quiescent current - 300 microA. Number of transmitter on bus - 32. |
| MAX135CPI | MAXIMIC | 15-bit ADC with parallel interface. |
| MAX543ACSA | MAXIMIC | CMOS, 12-bit, serial-input multiplying DAC. Linearity (LSB) +-1/2 |
| MAX6318LHUK42DZ-T | MAXIMIC | Microprocessor supervisory circuit with watchdog and manual reset,(watchdog input,reset output active-low,push/pull; active-high,push/pull).Factory-trimmed reset threshold(typ) 4.200V min, reset timeout 1.12sec,typ watchdog timeout 25.6sec |
| MAX532ACPE | MAXIMIC | Dual, serial-input, voltage-output, 12-bit MDAC. Error (LSB) +-1/2 |
| MAX851ESA | MAXIMIC | Low-noise, regulated, negative charge-pump power supplies for GaAsFET bias. 2mVp-p output voltage ripple. 100kHz chage-pump switching frequency. |
| MAX4512MJE | MAXIMIC | Quad, Rail-to-Rail, fault-protected, SPST analog switch. |
| MX7501SE | MAXIMIC | Low-power, monolithic, CMOS analog multiplexer. |
| MAX526DEWG | MAXIMIC | Calibrated quad, 12-bit, voltage-output DAC. INL(LSBs) +-1. Fast output settling 3micros. |
| MAX6318MHUK31BW-T | MAXIMIC | Microprocessor supervisory circuit with watchdog input (watchdog input,reset output active-high,push/pull and active-low, bidirectional).Factory-trimmed reset threshold(typ) 3.080V, reset timeout(min) 20ms, watchdog timeout(typ) 6.3ms |
| MXL1016CN8 | MAXIMIC | Ultra-fast precision TTL comparator. 10ns typ high-speed. |
| ICM7212AMIPL | MAXIMIC | Four digit display decoder/driver. LED, output code - code B, input configuration - micro P interface. |
| MAX8866TEUA | MAXIMIC | Dual, low-dropout, 100mA linear regulator with auto-discharge function. Preset output voltage 3.15V |
| MAX6320PUK27BY-T | MAXIMIC | Microprocessor supervisory circuit with watchdog and manual reset (watchdog input,manual reset input, reset output active-low, open-drain).Factory-trimmed reset threshold(typ) 2.700V, reset timeout(min) 20ms, watchdog timeout(typ) 1.6sec |
| MAX3480BEPI | MAXIMIC | Complete, isolated, 3.3V RS-485/RS-422 data interface. Data rate 250 kbps. |
| MAX6322HPUK36B-T | MAXIMIC | Microprocessor supervisory circuit with manual reset (manual reset input, reset outputs active-high, push/pull and active-low, open-drain).Factory-trimmed reset threshold(typ) 3.600V, reset timeout(min) 20ms |
| MX7545GUD | MAXIMIC | CMOS 12-bit buffered multiplying DAC. Error +-1/2 LSB. +-1 LSB gain accuracy. |
| MAX1271AENG | MAXIMIC | Multirange, +5V, 8-channel, serial 12-bit ADC. INL(LSB) +1/2,-1/2 |
| MAX222CWN | MAXIMIC | +5V-powered, multichannel RS-232 driver-receiver. |
| MAX474CPA | MAXIMIC | Dual, 10MHz single-supply op amp. |
| MAX792TESE | MAXIMIC | Microprocessor and non-volatile metory supervisory circuit. Reset threshold 3.06V |
| DG417DJ | MAXIMIC | Improved, SPST, NC analog switch |
| MAX539BC/D | MAXIMIC | +5V, low-power, voltage-output, serial 12-bit DAC. Error (LSB) +-1. 140microA supply current. Flexible output ranges 0V to Vdd. |
| MAX6316MUK47CW-T | MAXIMIC | Microprocessor supervisory circuit with watchdog and manual reset (watchdog input,manual reset input,reset output active-low,bidirectional).Factory-trimmed reset threshold (typ) 4.700V, min reset timeout 140ms, typ watchdog timeout 6.3ms |
| MAX6318MHUK33DY-T | MAXIMIC | Microprocessor supervisory circuit with watchdog input (watchdog input,reset output active-high,push/pull and active-low, bidirectional).Factory-trimmed reset threshold(typ) 3.300V, reset timeout(min) 1.12sec, watchdog timeout(typ) 1.6sec |
| MAX6312UK30D1-T | MAXIMIC | Multiple-input, programmable reset IC(push/pull reset output, factory-set reset threshold on Vcc, 1 additional undervoltage reset input, manual-reset input). Factory-trimmed reset thresholds 2.925(min) 3.075(max). Nominal timeout period 1ms. |
| MAX6317HUK38CY-T | MAXIMIC | Microprocessor supervisory circuit with watchdog and manual reset (watchdog input,manual reset input,reset output active-high, push/pull).Factory-trimmed reset threshold (typ) 3.800V, min reset timeout 140ms, typ watchdog timeout 1.6sec |
| MAX4581CUE | MAXIMIC | Low-voltage, CMOS analog multiplexer (8-channel). |
| MAX157AEPA | MAXIMIC | +2.7V, low-power, 2-channel, 108ksps, serial 10-bit ADC in 8-pin microMAX. INL (LSB) +,- 0.5 |
