| パートいいえ | メーカー | アプリケーション |
|---|
| MAX4518CSD | MAXIMIC | Precision, 4-channel, low-voltage, CMOS analog multiplexer. Single-supply operation (+2.2V to +15V) or bipolar-supply operation (+-2.2V to +-8V). |
| MAX6306UK25D2-T | MAXIMIC | Multiple-input, programmable reset IC (open-drain reset output, factory-set reset threshold on Vcc, 1 additional undervoltage reset input, manual reset input). Factory-trimmed reset thresholds 2.438(min),2.563(max) Nominal timeout period 20ms. |
| MXD1000SA30 | MAXIMIC | 5-tap silicon delay line |
| DG444DY | MAXIMIC | Improved, quad, SPST analog switch |
| MAX3222EPN | MAXIMIC | 3.0V to 5.5V, low-power, up to 1Mbps, true RS-232 transceiver using four 0.1microF external capacitor. Low supply current 300microA. Guaranteed data rate 120kbps. |
| MX7226KEWP | MAXIMIC | CMOS quad 8-bit D/A converter with separate input registers. Error +-2 LSB. |
| MAX4522ESE | MAXIMIC | Quad, low-voltage, SPST analog switch. |
| MAX706EPA | MAXIMIC | Low-cost, microprocessor supervisory circuit. Active-low manual reset input. Independent watchdog timer - 1.6s timeout. Precision supply-voltage monitor 4.4V. |
| MAX3286CHJ | MAXIMIC | 3.0V to 5.5V, 1.25Gbps LAN laser driver. |
| MAX521BCWG | MAXIMIC | Octal, 2-wire serial 8-bit DAC with Rail-to-Rail, unbuffered outputs. TUE(LSB) 2. |
| DG387ABA | MAXIMIC | General purpose CMOS quad analog switch. |
| MAX4536CPE | MAXIMIC | Quad, low-voltage, SPST analog switches with enable. 4 NO. |
| MAX8215EJD | MAXIMIC | +-5V, +-12V dedicated microprocessor voltage monitor. |
| MAX1637EEE | MAXIMIC | Miniature low-voltage, precision step-down controller. |
| MAX6318MHUK26CY-T | MAXIMIC | Microprocessor supervisory circuit with watchdog input (watchdog input,reset output active-high,push/pull and active-low, bidirectional).Factory-trimmed reset threshold(typ) 2.630V, reset timeout(min) 140ms, watchdog timeout(typ) 1.6sec |
| MAX4174ADEUK-T | MAXIMIC | Single, Rail-to-Rail, GainAmp op amp with precision internal gain-setting resistors. Rf/Rg inverting gain 1, 1+ (Rf/Dg) noninverting gain 2, -3dB BW 590kHz. |
| MAX6318MHUK44BZ-T | MAXIMIC | Microprocessor supervisory circuit with watchdog input (watchdog input,reset output active-high,push/pull and active-low, bidirectional).Factory-trimmed reset threshold(typ) 4.390V, reset timeout(min) 20ms, watchdog timeout(typ) 25.6sec |
| MAX4537EPE | MAXIMIC | Quad, low-voltage, SPST analog switches with enable. 4 NC. |
| MAX4075AOESA | MAXIMIC | Micropower, Rail-to-Rail, fixed-gain, dual, GainAmp op amp. Inverting gain 9V/V, noninverting gain 10V/V, -3dB BW 90kHz. |
| MAX306CWI | MAXIMIC | Precision, 16-channel, high-performance, CMOS analog multiplexer |
| MAX6321HPUK44BY-T | MAXIMIC | Microprocessor supervisory circuit with watchdog (watchdog input, reset outputs active-high, push/pull and active-low, open-drain).Factory-trimmed reset threshold(typ) 4.390V, reset timeout(min) 20ms, watchdog timeout(typ) 1.6sec |
| MAX4519CPD | MAXIMIC | Precision, dual 2-channel, low-voltage, CMOS analog multiplexer. Single-supply operation (+2.2V to +15V) or bipolar-supply operation (+-2.2V to +-8V). |
| MAX1666SEEE | MAXIMIC | Advanced lithium-lon battery-pack protector |
| ICM7242IJA | MAXIMIC | Fixed timer/counter |
| MAX6318LHUK50DX-T | MAXIMIC | Microprocessor supervisory circuit with watchdog and manual reset (watchdog input, reset output active-low, push/pull; active-high,push/pull).Factory-trimmed reset threshold (typ) 5.000V, min reset timeout 1.12sec, typ watchdog timeout 102ms |
| MAX1697TEUT-T | MAXIMIC | 60 mA, inverting charge pump with shutdown, 125 kHz. |
| MAX251EPD | MAXIMIC | +5V powered isolated RS-232 driver/receiver. |
| MAX4274AJEUA | MAXIMIC | Dual, Rail-to-Rail, GainAmp op amp with precision internal gain-setting resistors. Rf/Rg inverting gain 3, 1+ (Rf/Dg) noninverting gain 4, -3dB BW 690kHz. |
| MAX6318MHUK32DX-T | MAXIMIC | Microprocessor supervisory circuit with watchdog input (watchdog input,reset output active-high,push/pull and active-low, bidirectional).Factory-trimmed reset threshold(typ) 3.200V, reset timeout(min) 1.12sec, watchdog timeout(typ) 102ms |
| MAX6321HPUK32CW-T | MAXIMIC | Microprocessor supervisory circuit with watchdog (watchdog input, reset outputs active-high, push/pull and active-low, open-drain).Factory-trimmed reset threshold(typ) 3.200V, reset timeout(min) 140ms, watchdog timeout(typ) 6.3ms |
